前のトピックを表示 :: 次のトピックを表示 |
投稿者 |
メッセージ |
tkuhmone
登録日: 2014.08.26 記事: 56
|
日時: Sun Nov 16, 2014 4:58 am 記事の件名: UFO Capture v2.2 crashing (Hauppauge Impact VCB installatio) |
|
|
Hi,
has anyone seen this kind of behavior ?
I had UFO capture running on external USB capture device. That was working correctly.
For future purposes, I need to replace this with Hauppauge PCI-e cards. Drivers were installed to the card.
In this situation if you start UFO capture v2, error seen every time: "UM010: no video capture device". If OK button is clicked the UFO capture crashes.
Is there any way to return the setup at UFO capture v2 to default parameters ?
Since I have autostart enabled, I cannot access the program menus at all... And UFO capture v2 is not usable because of this crashing...
If remove physically the older USB grabber from the PC, still UFO capture crashes...
Help is highly appreciated....
thanks, Timo |
|
トップに戻る |
|
|
SonotaCo Site Admin
登録日: 2004.08.07 記事: 12671 所在地: 139.67E 35.65N
|
日時: Sun Nov 16, 2014 7:07 am 記事の件名: Re: UFO Capture v2.2 crashing (Hauppauge Impact VCB installa |
|
|
tkuhmone wrote: |
Is there any way to return the setup at UFO capture v2 to default parameters ?
|
Deleting "Settings.ufi" file in UFO2 directory will reset all settings of UFOCaptureV2. And re-install ax button on Operation sheet will change the install direcotry on the Windows registory.
But it does not concern about the installation of capture device driver. It is a matter of Windows and the device driver. |
|
トップに戻る |
|
|
tkuhmone
登録日: 2014.08.26 記事: 56
|
日時: Sun Nov 16, 2014 3:47 pm 記事の件名: |
|
|
I took a backup copy of settings.ufi, before deleting it. Now when file is deleted and program re-started (run as admin), then UFO Capture v2 asks registration code.
Now program starts normally I need to define the missing settings like location and save settings to new file. Also today, test the capture from the second Hauppauge card.
thanks, Timo K. |
|
トップに戻る |
|
|
|